76 ST4000 Plus Wheel & Tiller Autopilots Owner’s Handbook
Using a suitable tool, crimp the spade receptacles supplied to the cables
and connect, colour for colour, to the Drive terminals.
Socket i nst a ll at i on
1. Apply the template to the bulkhead.
2. Carefully drill an 18†mm (23/32†in) clearance hole and two
2.4†mm (3/32†in) pilot holes. Remove the template.
3. Fit the plug cap to the socket body.
4. Fit the O - ring (3) to the groove between the plug cap (2) and
socket body (1).
5. Pass the cable through the bulkhead and wire to the socket as
shown making sure the wires are connected to the correct pin.
1
2
3
1 Socket body 2 Plug cap 3 O-ring
To Next Page
Loading...
