48 ST4000 Plus Wheel & Tiller Autopilots Owner’s Handbook
ïRaytheon specified cables should be used at all times. Cutting and
rejoining these cables can compromise EMC performance and so
must be avoided unless doing so is detailed in the installation
manual.
ïIf a suppression ferrite is attached to a cable, this ferrite should not
be removed. If the ferrite has to be removed during installation it
must be reassembled in the same position.
Suppr essi on f e rr i t es
The following illustration shows the typical range of suppression
ferrites fitted to Raytheon equipment. Always use the ferrites specified
by Raytheon.
Co nn e ct i o ns t o ot he r e q ui p me nt
If your Raytheon equipment is going to be connected to other
equipment using a cable not supplied by Raytheon, a suppression
ferrite MUST always be fitted to the cable close to the Raytheon unit.
Ca b l i n g
ïAvoid running cables through bilges where possible
ïSecure coiled lengths at regular intervals
ïAvoid running cables close to fluorescent lights, engines, radio
transmitting equipment etc
To Next Page
Loading...
