Chap t e r 5 : Cu st o m i s i ng t he ST40 00 Pl us
35
Cha p t e r 5: Cust o mi si ng t he ST4000 Pl us
The ST4000 Plus provides setup and configuration options that are
used to adjust the settings for the ST4000 Plus itself, the compass, and
the autopilot.
Note: You should perform the post installation procedures described
in Chapter 7 before adjusting any other calibration features.
There are three setup levels:
ï User Setup, which controls compass setup, rudder calibration and
the ST4000 Plus display features
ï Intermediate Setup, which controls the CodeLock security feature
and displays status and version number information (see Chapter 4)
ï Dealer Setup, which controls the autopilot settings, and also the
calibration lock which can be used to prevent accidental access to
User and Intermediate Setup
The ST4000 Plus is calibrated at the factory to provide stable
performance for most yachts. Although many of the setup and
calibration features available in the ST4000 Plus can be fine tuned, it
should not normally be necessary to adjust the Dealer Setup values
once the initial installation and trials have been performed.
5.1 User Setup
The flow chart on the following page shows the User Setup control
procedure, and the setup screens with their default settings. Information
on the functions of the different settings is given in the remainder of this
section.
The following points should be considered:
ïMake sure that the autopilot is in Standby mode before you access
User Setup
ïIf the CAL L OCK screen is displayed instead of the initial page, you
need to turn off the lock feature in Dealer Setup
ïSetup options are always saved on exit
To Next Page
Loading...
