34 ST4000 Plus Wheel & Tiller Autopilots Owner’s Handbook
To enter your chosen code number on the ST4000 Plus display unit,
use the keys as shown.
D3394-1
Adjust
value at
the cursor
Move the
flashing
cursor to
the next
position
Adjust
value at
the cursor
To enter the code on any other master display unit, refer to the
handbook for that unit for details of the code entry procedure.
4.4 Code number problems
ïIf an incorrect code number has been entered, the four dashes are
redisplayed, with the prompt ìenter codeî. Repeat the procedures
illustrated above entering the correct four digit number.
ïIf you forget your code number, you must take your master unit to an
authorised dealer, together with appropriate proof of ownership
such as the original invoice. The dealer will be able to reset the unit
so that you can enter a new code.
To Next Page
Loading...
