84 ST4000 Plus Wheel & Tiller Autopilots Owner’s Handbook
Press st a ndby and auto together.
The ST4000 Plus should display the Vane mode screen, with the
locked wind angle and locked heading as shown.
D3565-1
Alternatively, if the wind data is not received , the ST4000 Plus will
display a NO DATA error message.
Sea Tal k i nt e rf a ce
If the ST4000 has been linked to other SeaTalk instruments via
SeaTalk, the link can be checked as follows:
1. Press st andby.
2. Select display illumination level 3 on any other SeaTalk instrument
or autopilot control unit.
The ST4000 Plus should immediately respond by switching on its
display illumination.
If the illumination does not switch on then a cabling fault exists in the
SeaTalk cabling between the ST4000 Plus control head and the
instruments/control unit.
To Next Page
Loading...
