Chap t e r 6 : I ns t al l at i on
69
Mounting socket installation (Part No. D002)
1. Drill a 12.5†mm (1/2†in) hole x 25†mm (1in) deep in the cockpit
seat.
2. If the structure at the mounting position is less than 25†mm (1†in)
thick, reinforce the underside with plywood bonded into position.
3. Install the mounting socket using a two part epoxy adhesive.
The pilot is capable of generating high pushrod loads. Ensure that:
ïThe epoxy is allowed to harden thoroughly before loads are applied.
ïAll holes are drilled to correct size and, where necessary, reinforcing
is provided.
Installation accessories
If it is not possible to install the drive unit directly onto the cockpit seat
or tiller as described, one of the following accessories (or a
combination) will ensure a perfect installation.
Pushr od ext ensions
The length of the pushrod can be extended using one of the standard
extensions.
Dimension C is modified as follows:
Dimension C Pushrod Ext ension Part No.
Lengt h L
622 mm (24.5 in) Standard dimension
648 mm (25.5 in) 25 mm (1.00 in) D003
673 mm (26.5 in) 51 mm (2 in) D004
699 mm (27.5 in) 76 mm (3 in) D005
724 mm (28.5 in) 102 mm (4 in) D006
749 mm (29.5 in) 107 mm (5 in) D007
775 mm (30.5 in) 152 mm (6 in) D008
To Next Page
Loading...
