38 ST4000 Plus Wheel & Tiller Autopilots Owner’s Handbook
Mode Bar
St a n d b y No t u sed
Aut o Heading error bar
Tr ac k Cr o s s Tr a ck Er r o r ( XTE) b a r
Vane Wi nd angl e error bar
Dockside rudder cal (DOCKSIDE RUDD CAL)
The dockside rudder calibration function automatically calibrates the
rudder range, for systems with a rudder reference unit. If a rudder
reference unit is not installed, the function sets the helm drive speed.
WARNI NG:
This procedure moves the helm, and should only be used when the
vessel is at the dockside.
The Dockside Rudder Calibration procedure is described in detail in
Chapter 7, Post Installation Procedures. If you start the procedure by
mistake, press any key to cancel it.
Dat a pages (DATA PAGE)
The next 7 User Setup pages allow the default settings for the Data
Pages to be modified. These are the SeaTalk/NMEA data†pages
available during normal operation (seesection 2.5).
Each setup page initially shows the title DATA PAGE. After 1 second,
this changes to the title of the data currently set for that page.
The available pages are as follows:
Dat a Displayed as
Sp ee d Kn o t s SP EE D KT S
Log LOG XXXX. X
Tr i p TRI P XX X. X
Average Speed, Knots AV. SPD KTS
Wi nd Di r ect i on E. g . WI ND PORT
To Next Page
Loading...
