68 ST4000 Plus Wheel & Tiller Autopilots Owner’s Handbook
Ba si c i n st a l l a t i o n
After establishing the control dimensions, the ST4000 Plus actuator
can usually be mounted directly onto the cockpit seat.
Tiller pi n i nst allat ion (Par t No. D001)
1. Drill 6†mm (1/4†in) hole x 25†mm (1†in) deep at point marked.
2. Using a two part epoxy (e.g. Araldite), epoxy the tiller pin in place.
3. Position the shoulder of the pin 12.5†mm (1/2†in) above the tiller
surface.
To Next Page
Loading...
