Chap t e r 3 : A d van c e d Oper at i o n
29
Alternatively, to cancel the alarm without accepting the waypoint
advance, press st a ndby to return to hand steering, or auto to return to
Auto mode.
Not e: The waypoint advance will only operate on pilots receiving
valid bearing to waypoint and waypoint number information.
Low bat t er y
LOW BATT
The Low Battery alarm sounds when the supply voltage drops below
10†V (±0.5†V).
Press st andby to clear the alarm and return to hand steering.
Start the engine to recharge the battery.
Wat ch alarm
WATCH
The Watch alarm is activated in Watch mode when the timer reaches 4
minutes. It is not available from Standby mode.
If you wish to set the Watch mode, the WATCH screen must be
configured as one of the Data Pages for display, as described in section
5.1.
To set and control the Watch alarm:
1. Select Auto, Track or Vane mode.
2. Press the disp key until the WATCH Data Page is displayed.
ïThe watch timer starts counting.
ïWhen the timer reaches 3 minutes, the text on the display starts
flashing to indicate the last minute of Watch alarm.
ïWhen the timer reaches 4 minutes, the audible Watch alarm is
activated.
3. Press auto at any time to silence the alarm and reset the timer to
4 minutes. (Pressing any other key resets the timer and performs
the keyís normal function.)
4. To clear Watch mode, press disp to display a different page, or
press st a ndby .
Note: You cannot engage Auto mode from Watch mode ñ pressing
auto only resets the Watch timer.
To Next Page
Loading...
