Chap t e r 6 : I ns t al l at i on
73
Dimension F Cut Length L
686 mm (27 in) 51 mm (2.00 in)
711 mm (28 in) 75 mm (3.00 in)
737 mm (29 in) 102 mm (4.00 in)
762 mm (30 in) 127 mm (5.00 in)
787 mm (31 in) 152 mm (6.00 in)
813 mm (32 in) 178 mm (7.00 in)
838 mm (33 in) 203 mm (8.00 in)
1. Mount the flange using three 6†mm (1/4†in) diameter bolts with
nuts and washers. Make sure the backing plate is installed correctly
ñ bed the flange on a thin coat of silicone sealant.
2. Screw the rod firmly into place using a tommy bar.
3. Roughen the end of the rod and inside the cap to provide a key.
Apply the two part epoxy adhesive provided to the rod end and
cap.
4. Place the cap over the rod end. Make sure the hole for the drive
unit mounting pin is facing up. Allow the epoxy adhesive at least
30 minutes to fully harden before applying any load.
To Next Page
Loading...
