1
Chapter 1: Operation
1.1 Getting started
Displayed information
Your ST60+ Speed instrument provides the following:
• Speed information.
• Log, trip and water temperature information.
• Count-up and race-start timers.
Switching on and off
All the time that power is applied to the instrument, you can use the speed
button to switch the instrument off and on as follows:
• To switch the instrument off, hold down the
speed button for approximately
5 seconds. After this time, a switch off count down of 4 seconds occurs. Keep
the
speed button pressed during this period, to switch off the instrument.
• To switch the instrument back on, hold down the
speed button for approxi-
mately 1 second.
When the power supply is switched off, none of the instrument buttons (including
speed) has any effect.
Notes: (1)
Each time power to the instrument is switched on, the instrument is ini-
tially in the on condition. You do not need to use the
speed
button to
switch the instrument on.
(2)
When the instrument is on, the operation of the
speed
button will
perform other operating functions, as described below.
1.2 Normal operation
Use the flow charts in this Chapter to operate your ST60+ Speed instrument. The
flow charts show the sequence of button presses and displays for the various
operating tasks. All button presses are momentary unless otherwise stated.
WARNING: Calibration requirement
To ensure this product performs at its best on your boat, you
MUST calibrate it before use, in accordance with the instructions
in Chapter 4, Calibration
. Do NOT use the product until you have
successfully calibrated it.
81261_1.book Page 1 Tuesday, November 29, 2005 12:42 PM
To Next Page
Loading...
Need help?
General
