EasyManuals Logo

Raymarine ST60+ SPEED INSTRUMENT User Manual

Raymarine ST60+ SPEED INSTRUMENT
54 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #46 background imageLoading...
Page #46 background image
34 ST60+ Speed Instrument Owner’s Handbook
Boat show mode
Ensure that the Boat Show Mode is set to OFF . If necessary, use the timer or
reset button to achieve this.
Factory defaults
You can use this screen to reset the operating parameters to the factory default
values. Use the
timer and reset buttons to make the required selection.
Note that the selection you make at this screen will be applied when you exit the
screen, so be sure you make the correct selection.
To retain the current values, ensure that the display shows
NO.
If you want to apply the factory defaults, change the display to YES. If you do
this, the values you have set up will be overwritten by the factory defaults when
you leave this screen.
Leaving Dealer calibration
Hold down the speed and trip buttons for 2 seconds to save your settings, exit
Dealer calibration and resume normal operation.
CAUTION: Do NOT enable Boat Show Mode
Do NOT enable Boat Show Mode. This must be used only for
demonstration purposes.
81261_1.book Page 34 Tuesday, November 29, 2005 12:42 PM

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Raymarine ST60+ SPEED INSTRUMENT and is the answer not in the manual?

Raymarine ST60+ SPEED INSTRUMENT Specifications

General IconGeneral
BrandRaymarine
ModelST60+ SPEED INSTRUMENT
CategoryMarine Equipment
LanguageEnglish

Related product manuals