Raymarine ST60+ SPEED INSTRUMENT User Manual

4 ST60+ Speed Instrument Owner’s Handbook
Trip
The trip distance is the distance covered since the last reset. It is reset to zero at
power up, and if you press the
reset button for 3 seconds.
Note: The trip distance can be reset only if the instrument is a master, i.e. connected to a
speed transducer.
Water temperature
The water temperature is shown in either degrees Celsius or Fahrenheit. You can
set the units you want during User calibration (see
Chapter4, Calibration ).
Timers
The timer button gives access to a count-up timer and to two race-start timers.
Times are either in seconds (S) or minutes (M), depending on the counter values.
Refer to the
Selecting timer flow diagram to display the required timer.
Once you have selected the required timer display, press the reset button to start
the timer running. When a timer is running, the delimiter ( . or : ) flashes. For lap
timing, press the
reset button. To stop and reset a timer to the start value, hold
down the
reset button for 1 second.
Once a timer is running, you can leave the timer screen and select any other
display. The timer will continue to run in the background.
Count-up timer
Race-start
timer 1
Race-start
timer 2
Selecting timer
When timer stopped
reset
starts timer When timer running
reset
gets lap time
timer
timer
timer
D8142-1
timer
81261_1.book Page 4 Tuesday, November 29, 2005 12:42 PM

Raymarine ST60+ SPEED INSTRUMENT Specifications

General

Brand	Raymarine
Model	ST60+ SPEED INSTRUMENT
Category	Marine Equipment
Language	English