6 ST60+ Speed Instrument Owner’s Handbook
1.3 Display settings
Illumination
When the instrument is first powered up, the display illumination is set to its lowest
level, to facilitate initial access to the buttons. To adjust the illumination level:
1. Hold down the
speed button for approximately one second, to enter the illu-
mination-adjust mode.
2. There are four preset illumination levels. Press the
speed button to cycle
through these levels until you reach the level you want.
3. Press any other button to leave the illumination-adjust mode.
Note:
The display will time out to normal operation 7 seconds after the last button press.
Contrast
To adjust the display contrast:
1. Hold down the
speed button for approximately two seconds, to enter the
contrast-adjust mode.
i. There are four preset contrast settings. Press the
speed button to cycle
through these settings until you achieve optimum display quality.
i. Press any other button to leave the contrast-adjust mode.
Note:
The display will time out to normal operation 7 seconds after the last button press.
1.4 Pop-up Pilot
A Pop-up Pilot facility enables instruments connected to SeaTalk to constantly
monitor any changes to the autopilot mode and to the course settings. If one of
these parameters changes, the new value is immediately displayed on the ST60+
instrument for 5 seconds, after which time the display reverts to the previous
display.
This facility can be enabled or disabled during User calibration (see
Chapter 4,
Calibration
).
1.5 Remote control
When connected to SeaTalk, the ST60+ Speed instrument can be controlled
remotely with a SeaTalk Remote Keypad Unit. Remote control of an instrument is
indicated by a REMOTE legend on the display, to indicate that the keypad has
control.
Details on how to use the remote control facility are given in the
SeaTalk Remote
Keypad Owner’s Handbook
.
81261_1.book Page 6 Tuesday, November 29, 2005 12:42 PM
To Next Page
Loading...
Need help?
General
