Chapter 4: Calibration 33
Response settings
The response values for both SPEED and VMG determine the frequency at
which information is updated. A low number provides a smooth response and a
high number a much livelier update.
Use the
timer (decrement) and reset (increment) buttons to set the required
value. Response values are from 1 to 15 .
Speed
response
VMG
response
Hold down
+
for approximately 12 seconds
Calibration
on/off
Entry screen
Boat show
mode
Factory defaults
resettimer
tripspeed
speed
speed
speed
speed
speed
resettimer
or
Use
to set required values
Dealer calibration
+
To leave calibration,
hold down
+
for approximately 2 seconds
tripspeed
D8156-1
81261_1.book Page 33 Tuesday, November 29, 2005 12:42 PM
To Next Page
Loading...
Need help?
General
