32 ST60+ Speed Instrument Owner’s Handbook
• If you want to carry out a second calibration run:
i. Press
trip to start the second calibration run (see
sheet 2
of the
Speed calibration
flow chart).
ii. Use the procedure described above in steps 4 to 7, to complete the
second run. At the end of the second run, the text END alternating
with the new calibration factor is displayed at the top of the screen.
iii. Press the
speed and trip buttons together, to store the new calibra-
tion factor, exit speed calibration and return to the Instrument status
screen.
Leaving Intermediate calibration
Hold down the speed and trip buttons for 2 seconds to save your settings, exit
Intermediate calibration and resume normal operation.
4.4 Dealer calibration
The Dealer calibration procedure (see
Dealer calibration
diagram) enables the
following parameters to be set:
• User calibration on/off.
• Speed response.
• VMG response.
• Boat show mode on/off.
Dealer calibration also gives access to the Factory defaults screen. This enables
you to re-apply the factory settings if you want to reset the instrument to a known
operating condition.
To commence Dealer calibration, hold down the
speed and trip buttons
together for approximately 12 seconds, to select the Dealer calibration entry
screen. Press the
timer and reset buttons together, to proceed with the
calibration, then use the
speed button to proceed from screen to screen as
calibration progresses.
User calibration on/off
Press the timer or reset buttons to toggle the User calibration either ON or
OFF as required. With OFF selected, User calibration and Intermediate
calibration are both disabled.
81261_1.book Page 32 Tuesday, November 29, 2005 12:42 PM
To Next Page
Loading...
Need help?
General
