Rayonex Rayocomp PS 10 - Page 41

4.4.5 RAH Module 10: Level test Page 41
After a few seconds the display changes and you can enter a RAH-programme
number
Please press now the following keys:
1 2
The Rayocomp PS 10 now adjusts the RAH programme number 04.00. The
display shows:
The RAH-programme number 04.00
(fig. 2) is a main RAH-programme.
Therefore, the figure 1 shows Level 1.
If, like in this example, level 2 and 3
also appear, the user knows, that
there are respective programmes on
sub and detail levels under the
current selected programme.
On the highest RAH-programme level,
45 programmes are available (fig. 6).
The programme 04.00 is the fourth
(fig. 5) of 45 programmes of the highest
level.
3 4 5 6
For the test, the polariser of the Rayocomp PS 10 is automatically switched
on N (fig. 3). There are currently no programmes selcted, that have to be
harmonised, visible under fig. 4.
Now, using the sensor, the test can begin. The functions are as follows:
Wooden handle
Changing the
polarisation
Next fundamental
frequency value
Previous fundamental
frequency value
in the internal store of
the PS 10
Storing a resonance
Wire spring
Sensor button