Instruction Manual TR-Mark III 250V Version 1.10 Preliminary Page 35 of 57
8.3.4 New Measurement
As described in chapter 7 Transformer, Measurement and Data Structure’, the
TR-Mark III 250V has only one measurement present at time. Starting the measurement
process again, will result in overwriting the results on the screen. Tapping the ‘save’ button
several time will have no effect
If you are up to do several measurements and save them, use the ‘New Measurement’
option.
You will be asked to save your present measurement, if you did not yet do so. Afterwards the
results on screen will be erased. And after a new ‘Go ABC’ or ‘Go…’, you can attach further
measurement to a transformer, by tapping ‘save’.
8.3.5 Working with Templates
As described in Chapter’8.2.1 New Transformer’, a new transformer profile can be created as
a template. What does that mean?
NOTE
Use this option, if you have to measure many transformers of the same
type.
The new profile will be created with a minimum of information, and it will be stored in the
archive of TR-Mark III 250V. In the info field ‘serial number’, ‘Template’ will automatically be
entered, and you will be asked to give a Name to the transformer.
This Template can be cloned via Archive menu. Then TR-Mark III 250V creates a
transformer profile based on the template. You will be asked to enter a new transformer
name and a serial number. After entering this information you will be led to main menu and
measurement can directly be started.
To Next Page
Loading...