5. Close the menu.
6. For more information on using the different sub-modes, go to:
"Basic Multi-Shot Mode" on the previous page
"Advanced Multi-Shot Mode" on the previous page
MOTION + STILLS
NOTE: This mode is available in Motion mode, but is only recommended in Stills mode.
Motion + Stills mode is identical to Continuous Record, except that when you initiate recording by pressing the
PWR/REC key on the camera, all other Record keys mark frames for the duration of the clip. (If you initiate recording
by pressing any other Record key, you can press any key mapped to “Record: Mark Frame” to mark stills.)
To use Motion + Stills mode, follow the instructions below:
1. Set the camera to Stills mode.
2.
Go to Menu > Settings > Recording > Mode.
3.
Select Motion + Stills from the Mode drop-down menu.
4.
Use the Limit Recording to fields to set the recording to end at a predefined frame limit (optional).
5. Close the menu.
6.
Press the PWR/REC key on the camera to start recording.
7.
Press the Record key on the media bay to mark a frame.
8.
Press the PWR/REC key on the camera to stop recording.
C OPYRI GHT © 2017 R ED.C O M , I NC 955- 01 38 _V6.3, REV-D | 110
WEAPON/EPIC-W OPERATION GUIDE
To Next Page
