Red Dragon WEAPON/EPIC-W - Media Bay and RED MINI-MAG Issues

MEDIA BAY AND RED MINI-MAG ISSUES
SYMPTOMS
LEDs on media bay do not illuminate when expected.
RED MINI-MAG does not mount to camera.
POTENTIAL RESOLUTIONS
Ensure RED MINI-MAG is fully inserted in the media bay.
Perform a system restore.
Reformat the RED MINI-MAG on the computer. For more information, see the DSMC Media Operation Guide at
www.red.com/downloads.
Remove and reinstall the media bay. For more information, go to "Remove the Media Bay" below.
REMOVE THE MEDIA BAY
To troubleshoot issues with the media bay or SSD, you may need to remove and re-install the media bay. Unless you
are troubleshooting media-related issues, DO NOT remove the media bay.
WARNING: Before installing or removing the media bay, you MUST turn off the camera.
REQUIRED TOOLS: T10 TORX driver
1. Turn off the camera.
2. Loosen the four (4) captive screws in a cross pattern (“X” pattern) using a T10 TORX driver.
3. Remove the media bay from the camera.
4. Inspect the connections and pins on the camera and ensure that they are clean and undamaged.
NOTE: DO NOT touch any part of the exposed boards or connectors.
5. Re-attach the media bay as soon as possible to prevent dust or debris from entering the camera. For more
information, go to "Install the Media Bay" below.
INSTALL THE MEDIA BAY
WARNING: Before installing or removing the media bay, you MUST turn off the camera.
REQUIRED TOOLS: T10 TORX driver
1. Turn off the camera.
2. Place the media bay on the camera, so that the mounting holes of the media bay align with the screw holes of the
camera.
3. Use a T10 TORX driver to tighten the four (4) captive screws by about two (2) turns in a cross pattern (“X” pattern).
DO NOT FULLY TIGHTEN.
4. Tighten the four (4) captive screws evenly. DO NOT exceed 70 in-oz, or damage may occur.
WARNING: DO NOT OVERTIGHTEN.
C OPYRI GHT © 2017 R ED.C O M , I NC 955- 01 38 _V6.3, REV-D | 196
WEAPON/EPIC-W OPERATION GUIDE