Red Dragon WEAPON/EPIC-W - Camera Displays N;A for Aperture; Cannot See Menus on LCD Touchscreen; Screen Freezes or Does Not Display; LCD Flicker

CAMERA DISPLAYS N/A FOR APERTURE
SYMPTOM
The camera displays N/A for aperture when a lens is attached.
POTENTIAL RESOLUTIONS
Ensure that your lens is completely locked in place.
Remove your lens mount. Check the connection points for damage or debris. Install your lens mount.
Perform a Hardware Rediscover. For more information, go to "Rediscover (Hardware Rediscover)" on page135.
Re-install your camera firmware.
If your camera is on beta firmware, downgrade to the release build.
If you are using a DSMC PL mount, go to Menu > Settings > Setup > Lens and ensure that power is enabled.
NOTE: Some lenses do not display the aperture information because they are incompatible. Some PL lenses do not
have i-technology data.
CANNOT SEE MENUS ON LCD TOUCHSCREEN
SYMPTOM
The LCD touchscreen does not display menus.
POTENTIAL RESOLUTION
Double-tap the LCD touchscreen to exit Clean mode.
SCREEN FREEZES OR DOES NOT DISPLAY
SYMPTOM
The screen freezes or does not display.
POTENTIAL RESOLUTION
Perform a Hard Restore. For more information, go to "Perform a Hard Restore" on page190.
LCD FLICKER
SYMPTOM
The LCD or monitor is flickering.
POTENTIAL RESOLUTIONS
Go to Menu > Settings > Display > Monitor Control and adjust the Frequency to 60 Hz.
Use a different cable.
Ensure cables are properly attached.
C OPYRI GHT © 2017 R ED.C O M , I NC 955- 01 38 _V6.3, REV-D | 188
WEAPON/EPIC-W OPERATION GUIDE