Red Dragon WEAPON/EPIC-W - Page 96

TIMECODE
NOTE: Using timecode requires ports that are only available on select DSMC2 expanders. For more information, go to
"Input/Output Connectors" on page215.
For more information about timecode, go to "Timecode, Genlock, Multi-Camera Setup" on page164.
TIMECODE
SOURCE
MODE DESCRIPTION
User
Provided
(Internal)
Use Real Time
Clock (RTC)
Uses the internal Real Time Clock as the timecode counter source. You can set the
hours, minutes, and seconds in the numerical boxes on the screen.
Set Manually Define a custom value as the timecode counter seed. Set the hours, minutes, and
seconds in the numerical boxes on the screen.
External Varies by
device
Uses the timecode from an external device connected to the timecode connector on
the camera.
SLATE
Use the Slate menu to add metadata to clips. After configuring the following fields, the information populates in the
Media menu when formatting media:
Cam ID
Cam Pos
NOTE: The scene name is limited to eight (8) characters.
AUTO-INCREMENT TAKE
To automatically increment the take number when the camera stops recording, follow the instructions below:
1.
Go to Menu > Settings > Project > Slate > Scene.
2.
Enter a value in the Take box.
AUTO SLATE
Frame values for Auto Head Frames and Auto Tail Frames on the Auto Slate tab, these values only show in-
camera. The Auto Head Frames and Auto Tail Frames metadata values are currently disabled in REDCINE-X PRO.
C OPYRI GHT © 2017 R ED.C O M , I NC 955- 01 38 _V6.3, REV-D | 96
WEAPON/EPIC-W OPERATION GUIDE