Reely ROAD Rex-X - Page 53

53
• Onlynowmustthethrottle/brakeleverbereleased(neutralposition).
 ThentheLEDashesandthemotoremitsbriefsoundsignals(beep-beep-pause-beep-beep).Thespeedcontroller
is now in programming mode.
If this is not the case, you released the throttle/brake lever prematurely and the programming mode has not
been started.
Proceed as described again.
The overall duration of how long you have to keep the throttle/brake lever in the full throttle position for
forward driving after the speed controller has been activated is about 15 seconds. Only then will the pro-
gramming mode be active.
• Thespeedcontrollerthenshowsthefunctioninwhichitisorwhichsettingvalueiscurrentlyactivebythenumber
ofLEDashesandsoundsignalsemittedthroughthemotor.
 Rightaftercallingtheprogramingmode,themotorrepeatsthesoundsignals„beep-pause-beep“andtheLED
ashesyellowbriey.Thismeansthatthefunctionnumberis„1“andthesettingvalueis„1“.
The throttle/brake lever of the transmitter then can be used for programing of the speed controller.
1) Put the throttle/brake lever at the transmitter into the forward driving position for the duration of
3 seconds (pull lever to the handle)
 Thismeans„yes“.TheLEDashesgreenandthemotorissuessoundsignals.Thenreleasethethrottle/
breakleveragain(neutralposition)tocallthenextfunctionanddisplaythefunctionnumberandtherst
settingvaluebyLEDashesandmotorsoundsignal.
2) Put the throttle/brake lever at the transmitter into the reverse driving position for the duration of 3
seconds (push lever away from the handle)
 Thismeans„no“.TheLEDashesredandthemotorissuessoundsignals.Thenreleasethethrottle/break
leveragain(neutralposition)todisplaythenextsettingbyLEDashesandmotorsoundsignal.
 Togettothenextfunction,eitherconrmasettingwith„Yes“(seeabove)orconrmallavailablesettings
with „No“.
 Ifallavailablesettingsareconrmedwith„no“,thepresentprogramingoftherespectivefunctionisnot
touched.Onlyifyouconrmthesettingwith„Yes“willtheprogrammingofthecorrespondingfunctionofthe
speed controller be changed and saved!
The function number and the setting are separated by a brief pause. The motor repeats, for example, the following
sound sequence:
Beep - beep - short pause - beep - long pause.........
This means that the speed controller is in function 2 (= brake force at forward driving) and the setting is 1 (= 25%).
• Notall9functionsneedtobegonethroughinsequence.Aprematureendofprogramingispossiblebydeactivating
thespeedcontroller.Allchangesperformedbeforethat(thathavebeenconrmedwith„Yes“,seeabove)areassu-
med.