Reely ROAD Rex-X - Page 54

54
Function 1: Driving mode (* = Default setting)
Setting Function
1 * Before switching from forwards to reverse driving, the throttle/brake lever at the transmitter must
beputinneutralpositionbriey(approx.2seconds).Thisavoidsgeardamagefromtoo-fast
changing between forward and reverse driving.
 Ifyoushiftdirectlyfromforwardstoreverse,thespeedcontroller‘sbrakewillbeactivated(the
vehicle will not go backwards!).
2 Reverse driving is deactivated.
3 Youcanonlyswitchfromforwardtoreversedrivingifthemotorhasstopped.
Function 2: Brake force at forward driving (* = Default setting)
Here you can set how much the vehicle is to brake when the brake of the speed controller is activated. At slippery
underground, a lower value should be set so that the vehicle does not break out when braking.
Setting Function
1 Brake force 25%
2 * Brake force 50%
3 Brake force 75%
4 Brake force 100%
Function 3: Maximum speed for reverse driving (* = Default setting)
To control the vehicle more easily at reverse driving, the maximum speed for reverse driving can be set to a lower
value.
Setting Function
1 Max. speed 25%
2 * Max. speed 50%
3 Max. speed 75%
4 Max. speed 100%
Function 4: Start-up dynamics (* = Default setting)
Thissettingadjustsstart-updynamicsthatspecieshowfastthevehicleaccelerateswhenstartingup.Thehigherthe
setting, the ,motor strain will there be on the motor and gear and the higher the current when starting up the vehicle.
If the underground has a good grip, a setting that is too high may cause the vehicle to somersault backwards due to
the torque being too high.
Setting Function
1 High limitation: Best for tail drive or slippery underground
2 Average limitation
3 Lowlimitation:Bestforall-wheeldriveonslipperyunderground
4 Very low limitation: Best for all-wheel drive
5 * No limitation: The maximum possible acceleration is only limited by the maximum current of the
driving batteries