Reflex Reflexomat Series - Starting Automatic Operation Mode

Commissioning
40
— English Reflexomat with Touch controller — 06.07.2016 - Rev. B
7.6
Starting Automatic mode
Automatic operation is executed as conclusion of the initial commissioning. The following prerequisites must be met for automatic
operation:
• The device is filled with compressed air and water.
• All required settings are defined in the controller.
Start the automatic mode at the operator panel of the controller.
1
. Press "AUTO“.
– The "CO1" compressor is switched on.
Reflexomat RS../1
800l
25%
1.4 bar
System
0l
NSP
0l
Note!
The commissioning process is now concluded.