— English Reflexomat with Touch controller — 06.07.2016 - Rev. B
The manual mode is intended for test and service tasks.
Manual mode enables you to select the following functions and to perform a test run:
• "CO1" compressor
• Solenoid valve in "PV1" overflow line
• Solenoid valve of the "WV1" make-up
You have the option to simultaneously switch multiple functions and to test them in parallel. Switch the function on and off by touching
the corresponding button:
– The button has a green background. The function is switched off.
Press the desired button:
– The button has a blue background. The function is switched on.
. Press "Manual mode“.
. Select the desired function.
• "CO1" compressor
• Solenoid valve in "PV1" overflow line
• Solenoid valve of the "WV1" make-up
The controller displays the change of the filling level and the
pressure of the
tank.
Reflexomat RS .../1
800 l
0%
Compr. Overflow Make-up
2.9 bar System
Kompr. "CO1" compressor
Überstr. Solenoid valve in "PV1" overflow line
Nachsp. Solenoid valve of the "WV1" make-up
Notice!
Manual operation can not be performed if safety
-relevant parameters are exceeded.
Switching is blocked if safety-relevant settings are exceeded.
To Next Page
Loading...
