Chapter 6 Advanced Settings
You can adjust various camera settings according to the environment where the
camera is installed under this menu.
➢ Anti-flicker: Use this feature if some devices such as TV screens and lights are
flickering.
● 50GHz: Used for Australia and the UK.
● 60GHz: Used for the USA and Canada.
➢ Exposure: Select the exposure level of the camera based on pre-defined
conditions. Select Manual to adjust shutter range and gain value of the camera
manually.
➢ White Balance: Change the way the camera processes white balance to correct
image colors. Select Manual to adjust red gain and blue gain.
➢ Day/Night: Set the camera’s color mode during different times of the day and
night.
● Color: the camera will show a colorful image which is usually in the day
time.
● Black and white: the camera will show the image only with black and white
color which is usually during the night when the IR LEDs are on.
● Auto: the camera will automatically switch between Color and Black and
white according to the light conditions.
➢ Backlight: Optimize brightness and contrast levels to compensate for
differences between dark and bright objects using either BLC or WDR mode.
This may improve image clarity in high contrast situations but should be tested at
different times of the day and night to ensure there is no negative effect.
➢ 3D-NR: Short for 3D-Noise Ratio, if Enabled, it may decrease the noise of the
image.
➢ LED light: Turn on/off the IR LEDs.
➢ Default: Restore to default settings.
Click OK to save and enable settings.
53
To Next Page
Loading...
Need help?
General
