NTP Setup
➢ NTP Server: The server you intend to use to access the current date and time.
The default is pool.ntp.org.
➢ NTP Port: The port that the NTP server uses.
➢ Enable Auto-Synchronize: enable or disable auto-synchronization.
➢ Synchronize Every: Set the Sync interval time.
Click Synchronize to synchronize the time now, click OK to save and enable
settings.
NOTE:
1. If you have enabled NTP - set this to the time zone where you are.
2. Some NTP servers are NOT fully compatible with DST (Daylight Savings Time). This
may cause your system to double-count adding one or removing one more hour than
they should, or cancel each other out. You may need to change your timezone to
adjust accordingly or simply not use NTP and DST simultaneously.
30
To Next Page
Loading...
Need help?
General
