Retsch ZM 300 - Device Views and Components; Front View Identification

The ZM 300 Ultra Centrifugal Mill
19
3.2 Views of the device
The numbering of components in the following views of the device is fixed and is used
in further figures of components in the Manual.
3.2.1 Front
Fig. 1: Front with closed device hood
No.
Component
Function
0
Impact protection
This hopper is designed as splashback protection and should always be
used, except for long-fibre material.
1
Feed hopper
For feeding of sample material. Guides the sample material into the
interior to the grinding gear.
1.1
Hopper for noise
reduction
When feeding sample material of < 4 mm, this hopper can be inserted
into the feed hopper. This funnel reduces the discharge of fine sample
material as well as noise.
2
Device hood
Closes the interior and guides the sample material.
3
Opening for through
cassette
Opening for positioning the through cassette. Is closed by means of a
rubber sleeve.
4
Emergency release
opening
For inserting the key for emergency release of the interior.
5
Stand opening
For installation of the stand of the DR 100 feed unit.
6
Touch display
Displays the parameters and is used to start and stop the device.
7
Control dial
For parameter setting
2
7
6
3
4
5
0
1
1.1