Retsch ZM 300 - Manual Sample Feeding Procedure

Operating the device
42
6.7.1 Feeding sample material manually
Manually feed sample material as follows:
Fig. 26: Device with closed device hood
1. Set the parameters for grinding on the
touch display (6) and with the control dial
(7).
2. Press on the touch display (6) to start
the grinding process.
3. Slowly feed the sample material into the
noise protection funnel (1) (arrow) (Fig. 26).
➔ The sample material is ground in the
device.
No.
Component
1
Noise protection funnel
6
Touch display
7
Control dial
7
6
1