Retsch ZM 300 - Software Update Procedure

Controlling the device using the touchscreen display
67
7.7.7 Software Update
Via the section (T15), the software can be updated.
A suitable USB medium must be connected to the USB interface.
• The USB medium must be formatted in the FAT32 file system.
• USB 3.0 mediums are not supported.
The main directory may only contain the software to be installed. The software is then
automatically detected by the device.
 Press the (T15) icon to carry out the update.
 Wait until the transfer and installation are complete. The background of the control dial
flashes blue until the touch display is restarted. This may take a few seconds.