Retsch ZM 300 - Replacing the Filter Cover

Maintenance
85
10.2.2 Replacing the filter cover
If a filter cover is heavily soiled, it must be replaced.
Replace the filter cover as follows:
Fig. 65: Position of filter covers
1. Switch off the device with the main switch
(16) at the rear of the device.
➔ Touch display (6) goes out.
➔ Device is switched off.
2. Remove the filter frame (22) as previously
described.
3. Replace the heavily soiled filter mat (22.2)
and clean the filter protection grid (22.1).
4. Fit the complete filter frame (22/22.1/22.2)
again and snap it into place.
➔ The filter mat (22.2) is replaced.
No.
Component
22
Filter frame
22.1
Filter protection grid
22.2
Filter mat
22
22.2
22.1