Ring sieve ........................................ 22, 37, 38, 82
Risk of injury due to dry ice ............................ 46
Rotor ................................................ 22, 37, 38, 82
Rotor shaft ..............................................20, 38, 81
Rotor speed ........................................................ 18
RPIO interface .................................................... 21
Rubber coupling for Retschbox .......................... 21
Rubber seal .................................................. 20, 72
Rubber sleeve .........................................20, 72, 74
S
Safety .................................................................... 9
Safety equipment ................................................ 12
Save .................................................................... 60
Schließkloben ..................................................... 84
Scroll bar ....................................................... 58, 59
Sensor areas ...................................................... 81
Serial number ............................................... 25, 63
Service address .................................................. 12
Service environment ..................................... 63, 66
Servicing ............................................................. 84
Sieve ................................................................... 17
Signalling device (on/off) .................................... 61
Signs ..................................................................... 7
Small accessories ............................................... 87
Software
update ............................................................. 67
version ............................................................. 66
Software update .................................................. 63
Software version ................................................. 63
Spare parts ......................................................... 87
Speed............................................................ 50, 55
Stand opening .........................................19, 23, 77
Start .................................................................... 50
Start delay ..................................................... 50, 55
Status display ............................................... 48, 50
Structural modifications and repairs ................... 12
Supply frequency ................................................ 25
Support ............................................................... 23
Switching the device off ...................................... 31
Switching the device on ...................................... 31
Symbols ................................................................ 7
system settings ................................................... 61
System settings ............................................ 50, 61
T
Target group ........................................................ 9
Technical data .................................................... 18
Temperature fluctuations ................................... 26
Temperature range ............................................ 27
Temperature sensor ........................................... 20
Temporary storage ............................................. 27
Through cassette ......................................... 72, 74
Through sleeve ............................................ 72, 74
Toggle screw ................................................ 44, 77
Toggle screw for hopper .................................... 23
Touch display .... 19, 29, 31, 32, 35, 38, 42, 44, 54,
77, 79, 81, 83, 84
Touchscreen display .......................................... 48
Transport ............................................................ 26
Transport damage .............................................. 26
Type plate .......................................................... 28
description ...................................................... 25
U
USB port ............................................................ 21
Use of the device for the intended purpose ......... 9
V
Vent .................................................................... 20
View of grinding tools und cassette ................... 22
View of the device with additional equipment .... 23
Views of the device ............................................ 19
Voltage ............................................................... 28
Voltage variant ................................................... 25
W
Warning ................................................................ 7
Information ....................................................... 8
Warranty claim ................................................... 26
Wearing parts ..................................................... 87
Y
Year.................................................................... 25
Z
ZM 300 Ultra Centrifugal Mill ............................. 17
Zyklonabscheider ............................................... 23
To Next Page
Loading...
