If you select [Kerberos Authentication], a password is sent using an encryption process that prevents
passwords from being revealed during transmission to the KDC server where authentication occurs.
If you select [Digest Authentication], a password is sent using an encryption process that prevents
passwords from being revealed during transmission to the LDAP server.
If you select [Cleartext Authentication], a password is sent to the LDAP server as is, without any
encryption processing.
If you select [Kerberos Authentication], proceed to step 19 to 21, and then proceed to step 22.
If you select [Digest Authentication] or [Cleartext Authentication], proceed to step 19 to 20, and then
proceed to step 22.
If you select [Off], proceed to step 22.
19. Enter the User Name, and then press the [OK] key.
When [Kerberos Authentication], [Digest Authentication], or [Cleartext Authentication] is selected for
the authentication setting, use the administrator account name and password. Do not enter the
administrator account name and password when using authentication for each individual or each
search.
Procedures for the user name setting differ depending on server environment. Check your server
environment before making the setting.
Example: Domain Name\User Name, User Name@Domain Name, CN=Name, OU=Department
Name, DC=Server Name
20. Enter the Password, and then press the [OK] key.
The user name and password are required for administrator authentication to access the LDAP server.
You can connect to the LDAP server using a user name and password stored in the Address Book. For
details, see "Registering SMTP and LDAP Authentication".
1. System Settings
50
To Next Page
Loading...
Need help?
General
