Installing Controller Options
D383 14 SM
1.3 INSTALLING CONTROLLER OPTIONS
1.3.1 IEEE 1284 INTERFACE BOARD (B679)
Accessories
Check the accessories and their quantities against the following list:
No Description Quantity
1 IEEE 1284 Interface Board B679 1
Installation
Turn off the main power switch and disconnect the power supply cord.
1. Remove the application cover ( x1).
2. Remove the cover [A] of the board slot ( x1).
3. Install the interface board [B] ( x2 knob screws).
Use a screwdriver to tighten the knob-screws. Do not tighten manually,
because this can disconnect the board.
4. Reattach the application cover ( x1).
If the 500-Sheet Finisher is installed, remove it before you attach the parallel
cable. Install the finisher again after you connect the parallel cable.
To Next Page
Loading...
