Image Problems
SM 4-47 D017/D018/D019/D020
Trouble-
shooting
4. Loosen all screws ( x7) [B].
5. Lift up the left front of unit until there is a 1 to 2 mm gap.
6. Tighten the 7 screws.
7. Insert a washer (#07080050, 1 mm thick) into gap [A].
8. Attach the washer in its position with an adhesive that sets quickly.
This washer will also absorb small amounts of shock.
9. Check if the parallelogram image still appears.
Procedure B
1. Remove the ADF [A], machine rear cover, scanner left cover, and scanner rear cover.
To Next Page
Loading...
