SP2xxx: Drum
D017/D018/D019/D020 5-24 SM
Printer - Rear Trailing Edge
10
In printer mode, adjusts the trailing edge erase margin on the reverse side of
duplex copies.
The actual trailing edge erase margin on the reverse side is this value plus
the value of SP2101-7.
The specification is 3 ±2 mm. See “Replacement and Adjustment - Copy
Adjustment” for details
[0.0 to 9.0 / 0.0 / 0.1 mm/step]
LD Power Adjustment DFU
2103*
[50 to 170 / 129 / 1/step]
Adjusts the LD power.
Do not change the value.
Test Mode dpi
2110*
Sets the scanning resolution (dpi). DFU
[See below / 8 / 0to18]
0: 400x400 dpi
4: 300x300 dpi
8: 600x600 dpi
2201* Development Bias Adjust
Printing
1
Adjusts the development bias during printing.
This can be adjusted as a temporary measure if faint copies appear due to
an aging drum.
[–1500 to –200 / –650 / 1 V/step]
ID Sensor Pattern
2
Adjusts the development bias for making the ID sensor pattern.
The actual development voltage for the ID sensor pattern is this value plus
To Next Page
Loading...
