SP2xxx: Drum
D017/D018/D019/D020 5-28 SM
2803* Developer Initialization Data
Vts
1
When the machine detects a new PCU (photoconductor unit) in the
machine, it checks the heat seals at the creation of the first ID sensor
pattern. After the agitator is rotated for 30 sec., the machine creates the
second ID sensor pattern and corrects the reference value of the TD sensor.
The corrected reference value for the TD sensor is recorded here.
ID Sensor PWM Value
2
Displays the PWM value of the ID sensor after performing the developer
initialization.
New PCU Check DFU
2804
This SP determines whether the machine is set to recognize a new PCU.
[0 to 1/0/1]
0: New PCU recognition on.
1: New PCU recognition off.
2901* Separation Voltage Adj
Front – Leading Edge
1
Adjusts the voltage that is applied to the separation plate during printing at
the leading edge of the paper on the front side.
If the copies have pawl marks at the leading edge, increase this voltage.
[–4000 to –1000 / –1800 / 1 V/step]
Front – Image Area
2
Adjusts the voltage that is applied to the separation plate during printing on
the image area of the paper on the front side.
If the copies have pawl marks in the image area, increase this voltage.
[–4000 to –1000 / –1800 / 1 V/step]
3 Rear – Leading Edge
To Next Page
Loading...
