Bit Switches
D361 96 SM
Communication Switch 0C (SP No. 1-104-013)
No Function Comments
end of the telephone numbers the machine
compares.
If it is set to 00, the machine will send the report to
the first Quick/Speed Dial that the machine
compared. If Quick Dial 01 is programmed, the
machine will send the report to Quick 01. If Quick
Dial 01 through 04 are not programmed and Quick
Dial 05 is programmed, the machine will send the
report to Quick 05.
Default setting – 05(H) = 5 digits
5-7 Not used Do not change the settings.
Communication Switch 0D (SP No. 1-104-014)
No Function Comments
0-7
The available memory
threshold, below which ringing
detection (and therefore
reception into memory) is
disabled
00 to FF (Hex), unit = 4 kbytes
(e.g., 06(H) = 24 kbytes)
One page is about 24 kbytes.
The machine refers to this setting before each fax
reception. If the amount of remaining memory is
below this threshold, the machine cannot receive
any fax messages.
If this setting is kept at 0, the machine will detect
ringing signals and go into receive mode even if
there is no memory available. This will result in
communication failure.
Communication Switch 0E (SP No. 1-104-015)
No Function Comments
0-7 Minimum interval between 06 to FF (Hex), unit = 2 s
To Next Page
Loading...
