Dedicated Transmission Parameters
D361 150 SM
Switch 03
No Function Comments
0 1 Second DIS or NSF
1 0 Not used
1 1 Disabled
second DIS or NSF before sending
DCS or NSS.
If the setting is “Disabled”, the bit
switch setting is used.
4
V.8 protocol
0: Off
1: Disabled
If transmissions to a specific
destination always end at a lower
modem rate (14,400 bps or lower),
disable V.8 protocol so as not to use
V.34 protocol.
0: V.34 communication will not be
possible.
If the setting is “Disabled”, the bit
switch setting is used.
5
Compression modes available in transmit
mode
0: MH only
1: Disabled
This bit determines the capabilities
that are informed to the other
terminal during transmission.
If the setting is “Disabled”, the bit
switch setting is used.
ECM during transmission
Bit 7 Bit 6 Setting
0 0 Off
0 1 On
1 0 Not used
1 1 Disabled
6
7
For example, if ECM is switched on
but is not wanted when sending to a
particular terminal, use the (0, 0)
setting.
Note that V.8/V.34 protocol and JBIG
compression are automatically
disabled if ECM is disabled.
If the setting is “Disabled”, the bit
switch setting is used.
To Next Page
Loading...
