When memory becomes full, the machine stops operation allowing you to remove the copy
pages delivered on the output tray.
Insert Separation Sheet
You can specify the number of copy pages for inserting the separation sheet from 1 to 999 pages in
increments of 1 page.
The default setting is 1 set(s).
Letterhead Setting
If you select [Yes] in this function, the machine rotates the image correctly.
The default setting is No.
Orientation-fixed (top to bottom) or two-sided paper might not be printed correctly depending on
how the originals and paper are placed.
Staple Position
Specify which Top 2 staples or Bottom shown on the initial display with priority.
The optional Finisher SR4010, Finisher SR4020, Finisher SR5000 is required to use this function.
• When the Finisher SR4010 is installed:
The default setting for "Staple Position 1" is Top 1.
The default setting for "Staple Position 2" is Slant.
The default setting for "Staple Position 3" is Left 2.
The default setting for "Staple Position 4" is Top 2.
• When the Finisher SR4020 is installed:
The default setting for "Staple Position 1" is Top 1.
The default setting for "Staple Position 2" is Center.
The default setting for "Staple Position 3" is Left 2.
The default setting for "Staple Position 4" is Top 2.
• When the Finisher SR5000 is installed:
The default setting for "Staple Position 1" is Top 1.
The default setting for "Staple Position 2" is Slant.
The default setting for "Staple Position 3" is Left 2.
The default setting for "Staple Position 4" is Top 2.
Punch Type
Specify which punch type (2 holes or 3 holes) has priority to be shown on the initial display.
The optional finisher is required to use this function.
The default setting for "Punch Type 1" is 2 Holes Left.
The default setting for "Punch Type 2" is 2 Holes Top.
Input/Output
137
To Next Page
Loading...
Need help?
General
