1. Press [RX File Print Qty per Sender].
2. Press [Number of Sets].
3. Enter the print quantity using the number keys, and then press [OK].
• Selecting [Same as Basic Settings] will result in the same setting made for "RX File Print Qty" of
"Reception Settings".
• If you make a mistake, press [Clear] or the [Clear/Stop] key before pressing [OK], and then try again.
Forwarding per Sender
This section describes how to specify Forwarding.
Specify when programming a Special Sender.
• One forward destination can be registered for each Special Sender. To register two or more forward
destinations, use group destinations. However a maximum of 500 destinations can be specified in a
group.
1. Press [Forwarding per Sender].
2. Select [On] or [Off].
If you select [Off], proceed to step 7.
Special Senders to Treat Differently
201
To Next Page
Loading...
