If you do not program any Special Senders, the machine prints the specified number of copies for all
received documents.
• You cannot use multi-copy printing with Memory Lock.
• You can specify up to 10 copies.
Forwarding
Print received documents, and then transfer them to those receivers programmed beforehand.
It is also possible to forward faxes sent only by senders programmed as Special Senders.
• If you select [Same as Basic Settings], the fax document is forwarded to the receivers programmed
in "Forwarding" under Facsimile Features.
• If you do not program any Special Senders, the machine transfers all incoming documents to the other
end receivers specified in "Forwarding" under Facsimile Features.
• You can set the fax destination, Internet Fax destination, IP-Fax destination, e-mail destination, or
folder destination, as a forward destination.
• If you have specified e-mail destination or folder destination for forwarding, you can specify the file
format used for forwarding. See "Parameter Settings" (switch: 21, bit: 3).
• p.201 "Forwarding per Sender"
• p.185 "Parameter Settings"
Print 2 Sided
Print on both sides of the paper.
• If you select the bypass tray for "Paper Tray", duplex printing is disabled.
Memory Lock
Store incoming documents from programmed senders (Special Senders) in memory without printing them.
People without the Memory Lock ID cannot print the documents, and therefore this function is useful for
receiving confidential documents . If you do not program any senders, the machine receives fax document
from all senders using Memory Lock reception.
Special Senders to Treat Differently
197
To Next Page
Loading...
Need help?
General
