• p.282 "Using SMB to Connect"
• p.293 "Using NCP to Connect"
Registering an FTP Folder
This section describes how to register an FTP folder.
1. Press [System Settings].
2. Press [Administrator Tools].
3. Press [Address Book Management].
4. Check that [Program / Change] is selected.
5. Select the name whose folder you want to register.
You can search by the registered name, fax number, folder name, e-mail address, or IP-Fax
destination.
6. Press [Auth. Info], and then press [ Next].
7. Press [Specify Other Auth. Info] on the right side of Folder Authentication.
When [Do not Specify] is selected, the FTP User Name and FTP Password that you have specified in
Default User Name / Password (Send) of File Transfer settings applies. For details, see "File Transfer".
8. Press [Change] under "Login User Name".
9. Enter the login user name, and then press [OK].
10. Press [Change] under "Login Password".
11. Enter the password, and then press [OK].
12. Enter the password again to confirm, and then press [OK].
13. Press [Folder].
Registering Folders
289
To Next Page
Loading...
