System Status/Job List Display Time
Specify how long to display the System Status and Job List display for.
The default setting is On, 15 second(s).
By selecting [On], you can specify a display time between 10 and 999 seconds.
Time Interval between Printing Jobs
Specify interval time after printing is completed until starting the next printing.
The default setting is Set Time, 3 second(s).
By selecting [Set Time], you can specify an interval time between 0 and 999 seconds.
Key Repeat
You can enable or disable repetition of an operation if a key on the screen or control panel is pressed
continuously.
The default setting is Normal.
Z-fold Position
If you specify Z-folding, set the fold-back position in 1 mm (0.1") increments.
The setting ranges of the folding position for each paper size are shown below:
• Metric version
• A3: 2-25 mm
• B4 JIS: 2-40 mm
• A4: 2-10 mm
• 11 17: 2-20 mm
• 8
1
/
2
14: 2-35 mm
• Inch version
• A3: 0.1"-1.0"
• B4 JIS: 0.1"-1.6"
• A4: 0.1"-0.4"
• 11 17: 0.1"-0.8"
• 8
1
/
2
14: 0.1"-1.4"
The default setting is 2 mm (Metric version) / 0.1" (Inch version).
• p.12
2. System Settings
60
To Next Page
Loading...
