SP5xxx: Mode
D017/D018/D019/D020 5-108 SM
66 Job Spool Clear: Start Time
This SP determines whether the job interrupted at power off is resumed at the
next power on. This SP operates only when SP5828 065 is set to 1.
1: Resumes printing spooled jog.
0: Clears spooled job.
69 Job Spool Protocol
This SP determines whether job spooling is enabled or disabled for each
protocol. This is a 8-bit setting.
0 LPR 4 BMLinks (Japan Only)
1 FTP (Not Used) 5 DIPRINT
2 IPP 6 Reserved (Not Used)
3 SMB 7 Reserved (Not Used)
90 TELNET (0:OFF 1:ON)
Disables or enables Telnet operation. If this SP is disabled, the Telnet port is
closed.
[0 to 1/1]
0: Disable
1: Enable
91 Web Operation (0:OFF 1:ON)
Disables or enables the Web operation.
[0 to 1/1]
0: Disable
1: Enable
145 ActIPv6LinkLocal
This is the IPv6 local address referenced on the Ethernet or wireless LAN
(802.11) in the format:
"Link-Local address" + "Prefix Length"
The IPv6 address consists of a total 128 bits configured in 8 blocks of 16 bits
each. These notations can be abbreviated. See "Note: IPV6 Addresses "
To Next Page
Loading...
