SP5xxx: Mode
SM 5-127 D017/D018/D019/D020
Service
Tables
1: Print
3 Total Counter
5850*
Address Book Function Japan Only
The machine is shipped ready to use with a G3 line. Use this SP to switch all at
once to G4 after adding a G4 line. If the G4 line becomes unusable for some
reason, you can use this SP to switch easily back to G3. Just touch
[Replacement].
Bluetooth Mode
5851
Sets the operation mode for the Bluetooth Unit. Press either key.
[0: Public] [1: Private]
Stamp Data Download
5853
Push [Execute] to download the fixed stamp data from the machine ROM onto
the hard disk. Then these stamps can be used by the system. If this is not done,
the user will not have access to the fixed stamps (“Confidential”, “Secret”, etc.).
You must always execute this SP after replacing the HDD or after formatting the
HDD. Always switch the machine off and on after executing this SP.
Remote ROM Update
5856
When set to “1” allows reception of firmware data via the local port (IEEE 1284)
during a remote ROM update. This setting is reset to zero after the machine is
cycled off and on. Allows the technician to upgrade the firmware using a parallel
cable
[0 to 1/1]
0: Not allowed
1: Allowed
5857 Save Debug Log
To Next Page
Loading...
