Paper Recommendations
37
4
❖ Cardstock
❖ Label paper
❖ OHP transparencies
Item Description
Paper thickness
105 to 160 g/m
2
(28.0 to 42.6 lb.)
Supported paper tray Tray 1 and bypass tray
Duplex supported size None
Notes • The number of sheets that can be printed in one minute is
approximately half that of plain paper.
• When using 135 g/m
2
(35.9 lb.) or heavier paper, prints
may be output with strong curls.
• When using 135 g/m
2
(35.9 lb.) or heavier paper, take
prints from the output tray frequently.
• Paper thicker than 160 g/m
2
cannot be printed onto.
Item Description
Supported paper tray Tray 1 and bypass tray
Duplex supported size None
Notes • The number of sheets that can be printed in one minute is
approximately half that of plain paper.
• Avoid using adhesive label paper on which glue is exposed.
Glue may stick to the inner parts of the printer, which can
cause paper feed problems, deterioration in print quality,
or premature wear of the print cartridge's photo conductor
unit.
Item Description
Supported paper tray Bypass tray
Duplex supported size None
Notes • When loading OHP transparencies, take care not to load
them upside down. Doing so may cause a malfunction.
• It is recommended to place one sheet at a time.
• Make sure to fan OHP transparencies every time before
printing. Leaving OHP transparencies loaded in the by-
pass tray may cause them to stick together and result in a
misfeed.
• If multiple OHP transparencies are fed at the same time,
load them one by one.
• When printing on OHP transparencies, remove the trans-
parencies one by one as they are output.
To Next Page
Loading...
Need help?
General
