95
9. Appendix
Moving and Transporting the Printer
CAUTION:
Repack the printer in its original packing materials for transporting.
Important
❒ Be sure to disconnect all cables from the printer before transporting it.
❒ The printer is a precision piece of machinery. Be sure to handle it carefully
when moving it.
❒ If the optional paper feed unit is installed, remove it from the printer, and
then move them separately.
❒ Do not grip on the tray area when lifting the printer.
Moving the printer in a short distance
Important
❒ Do not remove the print cartridge when moving the printer.
A Be sure to check the following points:
• The power switch is turned off.
• The power cable is unplugged from the wall outlet.
• The interface cable is unplugged from the printer.
B If tray 2 is installed, remove it.
• The printer weighs approximately 12 kg (26.4 lb.). When moving the printer,
use the inset grips on both sides, and lift slowly in pairs. The printer will
break or cause injury if dropped.
• Unplug the power cord from the wall outlet before you move the machine.
While moving the machine, you should take care that the power cord will
not be damaged under the machine.
• When you disconnect the power plug from the wall outlet, always pull the
plug (not the cable).
• When moving the printer after use, do not take out any of the toners, nor
the waste toner bottle to prevent toner spill inside the machine.
To Next Page
Loading...
Need help?
General
