7. With the white ferrite core above and the black ferrite core below, close the clamps [1] and [2] around
the cables on each side of the cores.
8. Remove the seals from the backs of the clamps.
9. Attach the clamps [1] and [2] to the rear panel of the right rear cover. Attach the clamps at the same
height so the cables are straight and level with the board connection to the controller board.
10. Measure the distances using the dimensions shown above and mark the positions with a pencil. (5
cm from the top edge, 3 cm from the side edges of the cover).
11. Remove the seals from the back of the black Velcro pads.
12. Below the scanning unit attach the black Velcro pads [1] and [2] to the right panel of the right rear
cover.
13. Determine which antenna has the black ferrite core on its cable and which has the white core on its
cable. (These are the ferrite cores attached to the rear panel in Step 9.)
2. Installation
198
To Next Page
Loading...
